Development of system to predict burr in endmilling

Kentaro Ohta, Hideki Aoyama, Noriaki Sano

Research output: Chapter in Book/Report/Conference proceedingConference contribution

Abstract

This paper describes a system to predict positions and dimensions of burrs formed in end-milling. Two kinds of burr models are applied for the prediction, namely "Poisson burr model" which estimates the burr formed by the cutting edge entering a workpiece and "rollover burr model" which estimates the burr formed by the cutting edge leaving a workpiece. The prediction takes into account the geometric parameters of the cutting tool used, physical properties of the workpiece, cutting conditions, and cutting force. Some of these values are derived using the NC simulator. Predictions and examinations were performed in some cutting conditions, and the predictions of top burrs were found to agree with the results of experiments.

Original languageEnglish
Title of host publicationProceedings of the 6th International Conference on Leading Edge Manufacturing in 21st Century, LEM 2011
Publication statusPublished - 2011
Event6th International Conference on Leading Edge Manufacturing in 21st Century, LEM 2011 - Omiya Sonic City, Saitama, Japan
Duration: 2011 Nov 82011 Nov 10

Other

Other6th International Conference on Leading Edge Manufacturing in 21st Century, LEM 2011
CountryJapan
CityOmiya Sonic City, Saitama
Period11/11/811/11/10

    Fingerprint

Keywords

  • Burr
  • Endmilling
  • Prediction

ASJC Scopus subject areas

  • Industrial and Manufacturing Engineering

Cite this

Ohta, K., Aoyama, H., & Sano, N. (2011). Development of system to predict burr in endmilling. In Proceedings of the 6th International Conference on Leading Edge Manufacturing in 21st Century, LEM 2011