A novel method for fabrication of die and mold in orbiting electrical discharge machining - Proposition of electrode design

Tutik Sriani, Yuuki Nakamura, Hideki Aoyama

研究成果: Paper

抜粋

Orbiting EDM offers a better machining quality toward static EDM. However, due to the relative motion between the tool electrode and the workpiece, the dimensional cavities will deviate from the design requirement. This research aims to develop a simulation method to fabricate tool electrodes which able to solves the raised problem by using Z-map model. The algorithm was adopted from EDM toolmaking process. Simulation result reveals that machining accuracy in orbiting EDM is dependent on the required features, type of orbit path used and orbit gap value. Examples are shown to demonstrate the effectiveness of the proposed method.

元の言語English
出版物ステータスPublished - 2009 12 1
イベント5th International Conference on Leading Edge Manufacturing in 21st Century, LEM 2009 - Osaka, Japan
継続期間: 2009 12 22009 12 4

Other

Other5th International Conference on Leading Edge Manufacturing in 21st Century, LEM 2009
Japan
Osaka
期間09/12/209/12/4

ASJC Scopus subject areas

  • Industrial and Manufacturing Engineering

フィンガープリント A novel method for fabrication of die and mold in orbiting electrical discharge machining - Proposition of electrode design' の研究トピックを掘り下げます。これらはともに一意のフィンガープリントを構成します。

  • これを引用

    Sriani, T., Nakamura, Y., & Aoyama, H. (2009). A novel method for fabrication of die and mold in orbiting electrical discharge machining - Proposition of electrode design. 論文発表場所 5th International Conference on Leading Edge Manufacturing in 21st Century, LEM 2009, Osaka, Japan.