A scalable 3D heterogeneous multicore with an inductive ThruChip interface

Noriyuki Miura, Yusuke Koizumi, Yasuhiro Take, Hiroki Matsutani, Tadahiro Kuroda, Hideharu Amano, Ryuichi Sakamoto, Mitaro Namiki, Kimiyoshi Usami, Masaaki Kondo, Hiroshi Nakamura

研究成果: Article

21 引用 (Scopus)

抜粋

The authors developed a scalable heterogeneous multicore processor. 3D heterogeneous chip stacking of a general-purpose CPU and reconfigurable multicore accelerators enables various trade-offs between performance and energy consumption. The stacked chips interconnect through a scalable 3D network on a chip (NoC). By simply changing the number of stacked accelerator chips, processor parallelism can be widely scaled. No design change is needed, and hence, no additional nonrecurring engineering (NRE) cost is required. An inductive-coupling ThruChip Interface (TCI) is applied to stacked-chip communications, forming a low-cost and robust high-speed 3D NoC. The authors developed a prototype system called Cube-1 with 65-nm CMOS test chips, and confirmed successful system operations, including 10 hours of continuous Linux OS operation. Simple filters and a streaming application were implemented on Cube-1 and performance acceleration up to about three times was achieved.

元の言語English
記事番号6684194
ページ(範囲)6-15
ページ数10
ジャーナルIEEE Micro
33
発行部数6
DOI
出版物ステータスPublished - 2013 11 1

ASJC Scopus subject areas

  • Software
  • Hardware and Architecture
  • Electrical and Electronic Engineering

フィンガープリント A scalable 3D heterogeneous multicore with an inductive ThruChip interface' の研究トピックを掘り下げます。これらはともに一意のフィンガープリントを構成します。

  • これを引用

    Miura, N., Koizumi, Y., Take, Y., Matsutani, H., Kuroda, T., Amano, H., Sakamoto, R., Namiki, M., Usami, K., Kondo, M., & Nakamura, H. (2013). A scalable 3D heterogeneous multicore with an inductive ThruChip interface. IEEE Micro, 33(6), 6-15. [6684194]. https://doi.org/10.1109/MM.2013.112