An estimation method of end-point impedance based on bilateral control system

Toshiaki Okano, Kouhei Ohnishi, Toshiyuki Murakami

研究成果: Article査読

抄録

This paper aims at developing an estimation method of end-point impedance. Human operators are constantly changing their end-point impedance for adapting to the surrounded environment and executing some complicated tasks, and it is highly meaningful to investigate these variations for the further understanding of human motion. Most of the conventional researches, however, have considered non-contact-point impedance or tasks that is only holding the vibrated sticks due to the experimental constraints. This paper proposes the estimation method of end-point impedance by using bilateral control system. The extra signal is added to the force controller for the impedance estimation. In addition, the effect of the bilateral controller is estimated and removed from the impedance estimation process for securing the applicability of moving tasks. The proposed method was validated through simulations and an experiment. The experimental result showed that the end-point stiffness can be estimated properly even if the operator robot was moving and changed its end-point impedance.

本文言語English
ページ(範囲)1151-1167
ページ数17
ジャーナルAdvanced Robotics
32
21
DOI
出版ステータスPublished - 2018 11月 2

ASJC Scopus subject areas

  • 制御およびシステム工学
  • ソフトウェア
  • 人間とコンピュータの相互作用
  • ハードウェアとアーキテクチャ
  • コンピュータ サイエンスの応用

フィンガープリント

「An estimation method of end-point impedance based on bilateral control system」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル