Application of powder suspended in dielectric fluid for fine finish micro-EDM of Inconel 718

Gunawan S. Prihandana, Tutik Sriani, Muslim Mahardika, M. Hamdi, Norihisa Miki, Y. S. Wong, Kimiyuki Mitsui

研究成果: Article

30 引用 (Scopus)

抜粋

Inconel 718 is an extremely hard and difficult-to-cut material used extensively in manufacturing because of its superior wear and corrosion resistance. Microelectrical discharge machining (micro-EDM) is one of the effective methods of machining this extremely hard material. However, due to short circuiting and arcing, the surface of microholes produced by micro-EDM has black traces and cones. This study investigates the influence of molybdenum disulfide (MoS2) powder suspended in dielectric fluid on the performance of micro-EDM of Inconel 718 with focus in obtaining quality microholes. It was observed that MoS2 powder suspension with 50 nm of size and 5 g/l of concentration can produce better quality microholes in Inconel 718. Moreover, it was also found that 50 nm MoS2 powder was the best powder size to achieve the highest material removal rate.

元の言語English
ページ(範囲)599-613
ページ数15
ジャーナルInternational Journal of Advanced Manufacturing Technology
75
発行部数1-4
DOI
出版物ステータスPublished - 2014 10 11

    フィンガープリント

ASJC Scopus subject areas

  • Control and Systems Engineering
  • Software
  • Mechanical Engineering
  • Computer Science Applications
  • Industrial and Manufacturing Engineering

これを引用