A plastic chip-scale package (CSP) smaller than conventional ones has been developed and applied to ATM switching systems. It uses a low-cost glass-epoxy substrate. Because glass epoxy is widely used in the printed circuit boards (PCBs) of ATM switching systems, its use in the CSPs mounted on a PCB reduces the difference in thermal expansion between the PCB and CSPs, thus lengthening CSP life. The power plane, ground plane, and thermal vias of the CSP are designed to offset the increased thermal resistance due to the CSP's smaller size. Simulation showed a thermal resistance for this CSP with copper layers and thermal vias of as much as 22% less than that of one with no copper layers or thermal vias. A six-layer test board mounting four CSPs was used to simulate a sub-board for ATM switching systems. The thermal resistance of the two CSPs located downstream was about 10% higher than that of the two located upstream. Two CSPs were developed for two types of application-specific ICs: a bus interface controller (BIC) and a peripheral interface circuit (PIC). Both CSPs were 18 mm square with a 0.8-mm outer solder-ball pitch and 256 outer balls. These CSPs occupied areas about 87% and 68% smaller than those of a conventional pin grid array (PGA) and quad flat package (QFP), respectively. The junction temperature of both CSPs satisfied the thermal condition. These high-performance CSPs are thus attractive for use in ATM switching systems.
|出版ステータス||Published - 1998 12 1|
|イベント||Proceedings of the 1998 IEEE/CPMT 2nd Electronics Packaging Technology Conference (EPTC'98) - Singapore, Singapore|
継続期間: 1998 12 8 → 1998 12 10
|Other||Proceedings of the 1998 IEEE/CPMT 2nd Electronics Packaging Technology Conference (EPTC'98)|
|Period||98/12/8 → 98/12/10|
ASJC Scopus subject areas