Development of system to predict burr in endmilling

Kentaro Ohta, Hideki Aoyama, Noriaki Sano

研究成果: Paper査読

抄録

This paper describes a system to predict positions and dimensions of burrs formed in end-milling. Two kinds of burr models are applied for the prediction, namely "Poisson burr model" which estimates the burr formed by the cutting edge entering a workpiece and "rollover burr model" which estimates the burr formed by the cutting edge leaving a workpiece. The prediction takes into account the geometric parameters of the cutting tool used, physical properties of the workpiece, cutting conditions, and cutting force. Some of these values are derived using the NC simulator. Predictions and examinations were performed in some cutting conditions, and the predictions of top burrs were found to agree with the results of experiments.

本文言語English
出版ステータスPublished - 2011 12月 1
イベント6th International Conference on Leading Edge Manufacturing in 21st Century, LEM 2011 - Omiya Sonic City, Saitama, Japan
継続期間: 2011 11月 82011 11月 10

Other

Other6th International Conference on Leading Edge Manufacturing in 21st Century, LEM 2011
国/地域Japan
CityOmiya Sonic City, Saitama
Period11/11/811/11/10

ASJC Scopus subject areas

  • 産業および生産工学

フィンガープリント

「Development of system to predict burr in endmilling」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル