DTM: Dynamic transfer mode based on dynamically assigned short-hold time-slot relay

Naoaki Yamanaka, Kohei Shiomotq

研究成果: Article査読

3 被引用数 (Scopus)

抄録

This paper proposes a new high-speed network architecture called Dynamic Transfer Mode, DTM. At the entrance of the DTM network, destination addresses such as IP addresses are converted into DTM routing information and attached to the packet header. In a DTM network, a connection is set up on-the-fly by sending a series of routing link identifiers to the destination, so burst data transfers like WWW traffic are efficiently carried. A connection between adjacent nodes is created and released dynamically within the burst'transfer period. This yields higher statistical multiplexing gain and improved bandwidth efficiency compared to with conventional STM. Time division multiplexing is utilized so delay jitter or cell loss, the major drawbacks of Asynchronous Transfer Mode, are avoided. This paper analyzes the performance of a DTM network and describes an implemented switching system. Because a DTM network uses source-routing and passive STM switching, it simplifies the core transit switch while localizing intelligence to edge nodes. A simplified core transit switch is well suited for future high-speed backbone networks.

本文言語English
ページ(範囲)439-445
ページ数7
ジャーナルIEICE Transactions on Communications
E82-B
2
出版ステータスPublished - 1999
外部発表はい

ASJC Scopus subject areas

  • ソフトウェア
  • コンピュータ ネットワークおよび通信
  • 電子工学および電気工学

フィンガープリント

「DTM: Dynamic transfer mode based on dynamically assigned short-hold time-slot relay」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル