Simultaneous detection of iodine and iodide on boron doped diamond electrodes

Stéphane Fierro, Christos Comninellis, Yasuaki Einaga

研究成果: Article査読

16 被引用数 (Scopus)

抄録

Individual and simultaneous electrochemical detection of iodide and iodine has been performed via cyclic voltammetry on boron doped diamond (BDD) electrodes in a 1 M NaClO4 (pH 8) solution, representative of typical environmental water conditions. It is feasible to compute accurate calibration curve for both compounds using cyclic voltammetry measurements by determining the peak current intensities as a function of the concentration. A lower detection limit of about 20 μM was obtained for iodide and 10 μM for iodine. Based on the comparison between the peak current intensities reported during the oxidation of KI, it is probable that iodide (I-) is ?rst oxidized in a single step to yield iodine (I2). The latter is further oxidized to obtain IO3-. This technique, however, did not allow for a reasonably accurate detection of iodate (IO3 -) on a BDD electrode.

本文言語English
ページ(範囲)33-37
ページ数5
ジャーナルTalanta
103
DOI
出版ステータスPublished - 2013 1 15

ASJC Scopus subject areas

  • 分析化学

フィンガープリント

「Simultaneous detection of iodine and iodide on boron doped diamond electrodes」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル