Tensile stress strain behavior of polypropylene toughened with Bi-modal SEBS

Hiroyuki Mae, Masaki Omiya, Kikuo Kishimoto

研究成果: Article査読

3 被引用数 (Scopus)

抄録

The objective is to characterize the effect of the bimodal distribution of rubber particles and its blend ratio on the mechanical properties of the thermoplastic polypropylene blended with two different styrene-ethylene- butadiene-styrene tri-block copolymer (SEBS) at the intermediate and high strain rates. Tensile tests are conducted at the nominal strain rates from 10 -1 to 102 (1/sec). Phase morphology is investigated to estimate the bi-modal rubber particle size distribution. In addition, the in-situ observation is conducted during uniaxially stretching within transmission electron microscopy (TEM) step by step to investigate the deformation events depending on the elongation of samples. The elastic modulus increased gradually as the blend ratio of large rubber particle increased. An increase in the rupture strain was found for the bimodal rubber-particle distributed blend system where the blend ratios of small rubber particle and large rubber particle were the same. This is because the smaller particles dominant blend systems show the band-like craze deformation while the localized plastic deformation is taken place in the larger particles dominated blend systems. The synergistic effect of these rubber particles gives rise to a strong increase in the ductility of these bimodal rubber-particle distributed polypropylene systems.

本文言語English
ページ(範囲)1129-1134
ページ数6
ジャーナルInternational Journal of Modern Physics B
22
9-11
出版ステータスPublished - 2008 4 30

ASJC Scopus subject areas

  • 統計物理学および非線形物理学
  • 凝縮系物理学

フィンガープリント

「Tensile stress strain behavior of polypropylene toughened with Bi-modal SEBS」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル