Tool-swinging cutting of binderless tungsten carbide

Zhiyu Zhang, Jiwang Yan, Tsunemoto Kuriyagawa

研究成果: Conference contribution

抜粋

Tool wear reduction is very important in cutting of ultra hard and brittle materials. In this paper, a tool-swinging cutting method was applied to reduce the wear of round-nosed diamond tools in cutting of tungsten carbide (WC). In this method, the geometrical center of the cutting edge was adjusted to be in coincidence with the rotation center of the B-axis table, and thus the cutting point could be changed along the cutting edge by swinging the tool about the B-axis center. Experimental results showed that the width of the flank wear land was greatly reduced compared to that in the conventional cutting. This work can shed light on ultraprecision machining WC parts without or with less need for subsequent polishing process.

元の言語English
ホスト出版物のタイトルManufacturing Engineering and Automation I
ページ727-730
ページ数4
DOI
出版物ステータスPublished - 2010 12 1
外部発表Yes
イベント2010 International Conference on Manufacturing Engineering and Automation, ICMEA2010 - Guangzhou, China
継続期間: 2010 12 72010 12 9

出版物シリーズ

名前Advanced Materials Research
139-141
ISSN(印刷物)1022-6680

Other

Other2010 International Conference on Manufacturing Engineering and Automation, ICMEA2010
China
Guangzhou
期間10/12/710/12/9

ASJC Scopus subject areas

  • Engineering(all)

フィンガープリント Tool-swinging cutting of binderless tungsten carbide' の研究トピックを掘り下げます。これらはともに一意のフィンガープリントを構成します。

  • これを引用

    Zhang, Z., Yan, J., & Kuriyagawa, T. (2010). Tool-swinging cutting of binderless tungsten carbide. : Manufacturing Engineering and Automation I (pp. 727-730). (Advanced Materials Research; 巻数 139-141). https://doi.org/10.4028/www.scientific.net/AMR.139-141.727