Transmit beam selection scheme for massive MIMO using expected beam responses

Yoshihito Kubo, Yukitoshi Sanada

研究成果: Article査読

1 被引用数 (Scopus)

抄録

Massive multiple-input multiple-output (MIMO) realizes simultaneous transmission to a large number of mobile stations (MSs) and improves frequency utilization efficiency. It is drawing attention as the key technology of the fifth-generation (5G) mobile communication systems. The 5G system is going to be implemented in a high frequency band and massive MIMO beamforming (BF) is applied to compensate propagation loss. In the conventional BF scheme, a transmit beam is selected based on the power of received signals over subcarriers. The signal on a different subcarrier is transmitted with a different directivity. To improve the accuracy of beam selection, this paper proposes a transmit beam selection scheme for massive MIMO. The proposed scheme calculates the expected responses of the signals over the subcarriers based on the relative directivity between a base station (BS) and a MS. The MS calculates the correlation between the received signals and each of the expected response sequences. It then selects the beam with the highest correlation value. It is shown in this paper that the proposed scheme can improve the average signal-to-noise ratio of a received signal by about 1.5 dB as compared with that of the power based search scheme. It is also shown that the proposed scheme with limited response coefficients can reduce the computational complexity by a factor of 1/100 while it still increases the average SNR by about 1.0 dB.

本文言語English
ページ(範囲)913-920
ページ数8
ジャーナルIEICE Transactions on Communications
E102B
4
DOI
出版ステータスPublished - 2019 4月

ASJC Scopus subject areas

  • ソフトウェア
  • コンピュータ ネットワークおよび通信
  • 電子工学および電気工学

フィンガープリント

「Transmit beam selection scheme for massive MIMO using expected beam responses」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル