UV laser photo-polymerization of elastic 2D/3D structures using photo-curable PDMS (Polydimethylsiloxane)

Oliver Suttmann, Kotaro Obata, Yasutaka Nakajima, Arndt Hohnholz, Jürgen Koch, Mitsuhiro Terakawa, Ludger Overmeyer

研究成果: Article

1 引用 (Scopus)

抜粋

2D/3D structuring of UV curable polydimethylsiloxane (PDMS) was developed using UV laser direct writing. In this technique, commercially available UV curable PDMS was locally polymerized to fabricate 1D and 2D single layer structures, as well as 3D multi-layer structures with sufficient stability in process resolutions. The tightly focused UV laser beam was scanned by an x-y galvano-metric mirror scanner on the UV curable PDMS layer coated on the glass substrate, so that 18μm of process resolution in X-Y plane was obtained. At the relevant wavelength of 355 nm, the absorbance of UV curable PDMS was 0.131, which is sufficient absorbance for a photo-chemical reaction induced by the UV laser used in this study. In addition, UV curable PDMS has a deep penetration depth, longer than 3 mm, which enabled the fabrication of a structure with an aspect ratio of 3 in a single layer. Furthermore, the fabricated structure demonstrated mechanical strength to emphasize its elasticity.

元の言語English
ページ(範囲)153-158
ページ数6
ジャーナルJournal of Laser Micro Nanoengineering
12
発行部数2
DOI
出版物ステータスPublished - 2017

ASJC Scopus subject areas

  • Instrumentation
  • Industrial and Manufacturing Engineering
  • Electrical and Electronic Engineering

フィンガープリント UV laser photo-polymerization of elastic 2D/3D structures using photo-curable PDMS (Polydimethylsiloxane)' の研究トピックを掘り下げます。これらはともに一意のフィンガープリントを構成します。

  • これを引用